40293 Media Handler MDH: <motor name> stepper motor has not completed previous command Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Stepper motors can be setup to run and not have the firmware wait for completion. If another command is sent to the same stepper motor before it has had the chance to complete its command this error will show up. If this occurs during normal operation, the main cause is programming error. Attempt the command again but if problem persists then restart the device. If this occurs due to monitor command, then just be patience and wait for the previous command to complete before sending the next one. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Programming error. motor name - This is the name of the stepper motor which failed. 06-Oct-2006 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:24 2008 PST